ParaPower 210 Rebuild
Hobby & Recreation Group
| This shows the original gage construction which was very minimum. It had only one hoop and I had several incidents where my hand would push against the net and the prop would trim my finger nails. These two pictures were taken in 2004. |
| These two pictures shows the rebuilt cage with all of the new tubes tack welded into place |
| I have added a third inside set of tubes to tie the net to and to allow access to the engine from the front of the cage on both sides of the harness. This also shows the homebuilt tuned pipe that we have built. It is still being tested. |
| This picture shows the inner tube access opening to the Bing carburetor. The original engine had a diaphragm carburetor on it. |
| This picture shows the new bottom of the cage and the support tubing. This design has increased the strength of the cage by a great amount. |
| These two views shows the paramotor with its new homebuilt prop mounted. |
| These two views shows the paramotor painted and with its netting installed and ready to fly for the 2009 flying season. |
 | |  |